First remove the screw on the side.


Then carefully pull off this part which is attached by three plastic clips in the area arrowed,
just remember these panels are made from hard foam and can break easily so do not
force it off.


Then remove the three plastic clips to re-use when re-fitting.


Next remove the screw from the next panel.


Then remove the four allen key bolts from the window winder




Next remove the allen key bolt from the centre


You can now start to remove the large panel from the several plastic clips that hold it
to the door, start from the back and work forward without breaking the foam panel.


You will need to get behind the panel and pull out the two plastic screws that hold the handle guard in place.



Carefully remove the door panel around the door guard.




Next twist off the handle guard.


The door cards are held in place by six plastic clips as shown, but remember these door
cards can crack really easy if forced off.


If nothing has broken you should be left with these pieces.

The below picture shows the areas where you'll need to adjust


No.1 Will adjust the window tilt inwards or outwards at the top by the roof seals,
only adjust these if you have to, only adjust slightly, as A, you can
lose the screw and B, adjust too far in and the window won't go up.
The best thing is to adjust in small movements and wind the window up and down to make
sure it works properly.


No.2 These two bolts will raise or lower the front or back of the window


No.3 This disc will rotate and will adjust the height of your window
(see below instructions for adjusting this)




Remove No.1 screw, then loosen the bolt No.2 from behind, do not remove bolt and
leave in place so the disc can rotate (make a note of its original position)


The disc will pivot around the bolt and will increase or decrease the distance from
the bar highlighted in the second picture.
To raise the window swing the disc clockwise (to increase the
distance from the bolt to the bar when the window is fully up) , re-tighten the bolt,
then check your window fits better to the seal, once the right position is correct screw
back No.1 screw back into place.




Double check the windows shut ok with the door open and when closed from
within the car BEFORE re-fitting the door panels back on.

You can stick the door cards back on with Velcro rather than
re-using the six plastic clips.